Professional production EL panel products for 15 years

Connect A Wire Additional Monitors To Your Car Dvd

by:Huihang     2021-03-14
Connect A Wire Additional Monitors To a Car DVD Recently, more and more vehicle owners like to be able to a car dvd system on their cars. Several cars have only one monitor to take the video. But in this situation, people that sitting in the rear seat can avoid seeing the screen, which comes with the dash panel. So you could find a monitor your past headrest for the front passenger's or driver's seat. The steps are not complicated for that monitor build. Here are the steps: you need to measure measurement of the headrest figure out the headrest monitor's measurement. if possible, remove the headrest from the seat and hung it on a table or on the floor. put the headrest monitor on finest of a portion of paper, draw the outline having a pencil. And after which cut the paper template with manboobs of scissors. put the paper template on the backside among the headrest and draw the outline around it using a pen or pencil. Then draw an 'X' near the inside the actual outline been recently traced. cut heli-copter flight headrest's part along the lines among the X you drew over a headrest having a knife. Cut of the corners, and leave 1/2 inch of material around the perimeter on the opening. peel back the outer covering of the headrest and remove the padding or foam to make room for the dvd examine. Remove the padding or foam unless you reach the metal bracket of the headrest. Then clean the padding and foam. drill atiny low hole regarding the bottom side of the headrest for the wires that needed to get in touch the dvd monitor. place the whites of hook-and-loop fasteners on the metal bracket of the headrest immediately after which set it back into position along at the seat. put the playback quality cables together with headrest bars and with seat to the floor. Develop a tiny hole within the rug around flooring below the seat, with a knife and hang the video wires up to the dash panel. connect the video cables to your back from the car dvd system. If possible, practical, then focus pull the unit out constitute the dash to connect the video cables. Please make certain you connect the wires to the video-out port on the dvd program. put the opposite end from the hook-and loop fasteners for your back in the dvd monitor, connect film cables on the video-in port on the monitor after that set the dvd monitor in the headrest exposing. Car monitor is one part of the car dvd gps navigation system. Besides, you might possibly add an automotive camera and parking radar on the car to build car more comfortable and in order to dirve.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...